Boost Logic 750HP Front Mount Intercooler Kit for
Lexus 92-97 SC300 and 93-97 Toyota Supra

Parts Included With your FMIC Kit:

• 5 Mandrel Bent Aluminum Intercooler Pipes
• 2.5” Silicone Couplers(3)
• 2” to 2.5” Silicone Reducer(1)
• 2.5” to 2.75” Silicone Reducer(2)
• 3” to 2.5” Silicone Reducer(1)
• 2.5” Clamps(12)
• 3” Clamps(3)

Remove plastic under panels.

Front Mount Installation

The area behind the bumper should look like this:

The top bracket of the intercooler is mounted in this location.

The bottom of the intercooler needs to be mounted on the lower radiator support.

The intercooler has 2 aluminum brackets on the side. These are mounted to the frame rail.

The passenger side:

The driver's side

The mounted front mount should look like this.

Intercooler Piping Install

#1 Intercooler Pipe

The compressor housing may need to be rotated to ensure correct fitment of the #1 intercooler pipe.

#2 Intercooler pipe

This intercooler pipe will fit underneath the power steering cooler lines and will go over the sway bar. The power steering cooler lines may need to be slightly bent upwards. The AC lines that run below the frame rail will need to be relocated downwards. To do this, you will need to cut the brackets that bolt the AC lines to the frame rail. DO NOT loosen the 10mm nuts holding the AC lines together. Doing this will cause all your freon to leak out.

The relocated AC lines to clear the #2 intercooler pipe..

#3 Intercooler Pipe

ATTN: For 92-97 Lexus SC300 vehicles, the AC Dryer will need to be relocated up to fit the #3 intercooler pipe. You will need to loosen the clamp around the AC dryer and carefully bend the AC lines up. The AC dryer will be relocated ~2" upwards.

The clearance between the AC dryer and #3 intercooler pipe.

Here is the #3 intercooler pipe installed.

Cutting the plastic panels to fit the new #3 intercooler pipe.

Drivers side plastic panels

#4 Intercooler Pipe

Cutting passenger side panel to fit #4 intercooler pipe

Fitting the #4 intercooler pipe

#5 Intercooler Pipe